Hi, in the book ‘ESP32_CAM_Projects_eBook_V1_3.pdf’ the schematic picture of the FTDI programmer on page 49 shows a different pinout than the picture of the FTDI programmer on page 50, exactly the other way round. This is unfortunate as I was following the schematic image and was therefore not immediately successful. Unfortunately, the pin designations on the PCB of my FTDI programmer were very difficult to read. Greetings to Portugal, where the sun is probably shining, while it is cloudy, slightly rainy and quite cold here. Michael
Thanks for pointing that out.
It is always better to check the label on the board itself. There are several FTDI programmers from different vendors and even though they have the same pins, the order might differ.
Were you successful in uploading the code? Do you need any help with that?
Yes, today is a lovely sunny day.