execute my ES32 after applying the power…..

Q&A Forum › Category: ESP32 › execute my ES32 after applying the power…..

0 Vote Up Vote Down

Marco Torrico asked 7 years ago

Hello,

How could I automatically execute the code on my ES32 after applying the power?
thanks in advance!
Mark

1 Answers

0 Vote Up Vote Down

Rui Santos Staff answered 7 years ago

Hello Marco!

After powering your ESP32 board, the sketch that you’ve uploaded to your ESP32 will automatically run/execute. If it’s an Arduino sketch, it starts by running the setup() code first. Then, runs the loop() code continuously.

Regards,
Rui