Anders Carlsson asked 4 months ago
Hello!
Everything works and I have calibrated the screen and also entered the values I got from the calibration. And those values are nearly in line with the values in the book
For me in the lower left corner I would like to have x=0 and y=0 and if I go to the right x should increase and if I go up y should increase.
I have changed the number suggested from 2-0. And I have also tried with the numbers from 0-4. I can make x increase but then y is wrong and also make y increase but then x is wrong.
What am I doing wrong?
Regards Anders
Sara Santos Staff answered 4 months ago
Hi.
What board model do you have?
Does it have two USB ports?
Regards,
Sara
Anders Carlsson answered 4 months ago
Hello!
The board is ESP32-2432S028R and have only one usb port.
Regards
Anders
Sara Santos Staff answered 4 months ago
Hi.
Unfortunately, I don’t think I can help with this.
The display coordinates are assigned a certain way and if you rotate the screen, everything will rotate.
On the following link, you can find a long discussion about coordinates and rotation. Maybe that can help you:
Regards,
Sara
Anders Carlsson answered 4 months ago
Hello!
Everyting works so I leave it, I was just curious if I did something wrong.
So thank`s Sara
Regards
Anders
Sara Santos Staff answered 4 months ago
Ok.
I’ll mark this issue as resolved. If you need further help, you just need to open a new question in our forum.
Have a great new year.
Regards,
Sara