Robert Johns asked 4 years ago
I’ve been going thru the course for home automation and I’m up to module 5 but stuck. There is no information on how to design the interface with the LED and brightness slider like it shows. Even the video does not have it.
Page 67 starts out saying drag a button node to the flow but just stops there?? Because this is never completed, there is no option to create tabs if I go to the dashboard. The dashboard page just says: “Welcome to the Node-RED Dashboard
Please add some UI nodes to your flow and redeploy.”
Other than that, it’s been going good.
Thanks,
Bob
Robert Johns answered 4 years ago
Cancel this. 😉
I found the info I needed. The video had me a little confused as it doesn’t show how to make the LED w/slider that it shows in the first few frames. I did find it in the .pdf file however.
Sorry for the mixup.
Bob
Sara Santos Staff answered 4 years ago
Ok.
I’ll close this question.
If you need further help, you just need to open a new question in our forum.
Regards.
Sara