In Mod 8 Unit 2 on Page 424, a BME280 is shown with 4 pins along the top edge of the PCB.
The pins are (left to right): SCL, SDA, GND, VIN.
When I orient my BME280 the same as the one on page 424
my pins are (left to right): SDA, SCL, GND, VIN.
I’m wondering if the picture on page 424 is wrong?
Can you verify for me that your BME280 is the same as mine or are the pins on your BME280 (SDA,SCL) reversed from mine?
Yes, you are right. The pins on the image are reversed.
My BME280 is probably the same as yours.
But, you just need to keep in mind you need to connect SDA to SDA and SCL to SCL.
I did as you said, and it worked well (provided you don’t mix up the MAC addresses!).
I’m getting to the end of the tutorial, and I just can’t believe how much stuff is in this course!
Thanks for your fine work,