Bill DeRyk asked 2 years ago
Coarse MODULE 4 UNIT:2: Having a problem with DIYmall bd, ESP32 DEVKIT_V1.1.not sending an IP address to the monitor. Baud rate set to 115200 and Deleted your network credentials. This is the monitor output after pressing the EN push button. No IP address is displayed.
...............ets Jul 29 2019 12:21:46
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0018,len:4
load:0x3fff001c,len:1044
load:0x40078000,len:10124
load:0x40080400,len:5856
entry 0x400806a8
Connecting to
...................................
1 Answers
Sara Santos Staff answered 2 years ago
Hi.
That usually happens if you don’t insert your network credentials correctly, or when the board is so far away from the router that it can’t catch the wi-fi signal.
I think the issue might be that you didn’t insert the network credentials correctly. Please double-check that.
Let me know if that solves the issue.
Regards,
Sara