ecarter1024 asked 4 years ago
Followed the instructions for this in the webserver book. Works fine but I found I had to press the “boot” button to get the screen shown in the book. “Enable” button does not appear to do anything
After uploading, open the Serial Monitor at a baud rate of 115200. Press the ESP32
“ENABLE” button. It should print the content of your .txt file on the Serial Monitor.
1 Answers
Sara Santos Staff answered 4 years ago
Hi.
Maybe you have a different board?
What is the board that you have?
In theory, the ENABLE button resets the board, and the BOOT button puts the board in flashing mode.
Your board may have the labels swapped??
Regards,
Sara