WiFi Sketch not talking to Serial Monitor

Q&A Forum › Category: ESP8266 › WiFi Sketch not talking to Serial Monitor

0 Vote Up Vote Down

Paul asked 6 years ago

Two squares an X and another square show up on the Serial Monitor when I run the WiFi Sketch.

4 Answers

0 Vote Up Vote Down

Rui Santos Staff answered 6 years ago

Hello Paul, did you select the baud rate in the Arduino IDE serial monitor? (It’s usually 115200)

0 Vote Up Vote Down

Paul answered 6 years ago

Yes the baud rate is 115200

0 Vote Up Vote Down

Paul answered 6 years ago

I set the baud rate to 115200 and now I get the IP address. When I enter the IP address in my browser I get “Authentication Required” “Username – Password” What username and password does it want? I tried every password I know and nothing works.

0 Vote Up Vote Down

Rui Santos Staff answered 6 years ago

Hello again, it’s explained in the eBook how to change the username and password, but the default settings are:

username: user
password: pass

Let me know if that works for you!